|
|||||||
产品规格型号 Specification |
产品规格型号 Model | PAU unit | ||
安装方式 Type | PAU-800RW | ||
性能 Performance | 温度控制范围 Temperature control range | -5 to 65 | |
温度控制精度 Temperature control accuracy(K) | ?.5 | ||
制冷功率 Cooling capacity(W) | 600(At ambient temperature of 25篊? | ||
允许环境温度 Allowable ambient temperature | 20 to 30(Operational temperature range 15 to 45) | ||
允许环境湿度 Allowable ambient humidity(%) | 10 to 85 | ||
外观 Appearance | 体积 Outside dimensions(mm) | H1245×W400×D700 | |
重量 Weight(kg) | 85 | ||
Blower duct joint diameter(mm) | ?5 | ||
电源 Electrical characteristics |
电源 Power supply | 1 phase 100V 50/60Hz | |
电流 Operating current(MAX)(A) | 18.5/19.0 | ||
电机功率 Power consumption(MAX)(W) | 1900/1950 | ||
组成装置 Components | 压缩机 Compressor | Rolling piston rotating type | |
Condenser, Cooler | Fin and tube | ||
Heater | Sheathed heater with fin (1000W) | ||
Blower air discharge rate (m3/min) |
(For cooler) Sirocco fan |
1.6/1.8 | |
(For condenser) Axial fan |
4.0/4.7 | ||
Coolant controller | Capillary tube | ||
Temperature sensor | Thermocouple(Type K) | ||
Temperature control | Electronic digital setting indicating PID control | ||
Protective device |
Compressor | Overcurrent relay(Manual reset)Surge absorber Motor protector(Automatic reset) | |
Heater | Overheat protection thermostat(100篊, OFF) Thermal fuse(119篊) | ||
Blower fan(For cooler) | Surge absorber | ||
Main circuit | Ground-fault circuit breaker |
Note: Temperature setting range: These values are obtained at the air discharge port of the PAU unit in a surrounding environment of 25篊/40% RH. The PAU unit may not offer the rated temperature control accuracy depending on the ambient temperature/humidity. Blower air discharge rate: This unit is not provided with a blower fan motor. When using this unit, be sure to connect the FFU. When the airflow in the FFU is insufficient, the EMERGENCY lamp illuminates. Make sure that you do not excessively reduce the volume of the evolving airflow to prevent freezing. (For more information, please contact our sales representative.) Cooling capacity: These values are obtained in a surrounding environment of 25篊/40% RH. Allowable ambient temperature: Performance does not cover all temperature control ranges. *This unit should basically be provided with a heat-insulating hose + internal circulation. Take a heat insulation measure for the target enclosure. *Switch the cooler to the dehumidifier mode every 30 minutes. |